Your dryer probably makes your life a whole lot easier. You don’t have to take your clothes down to the laundromat, which is going to save you time and money. However, when the appliances you rely on start to go haywire, you might find yourself incredibly inconvenienced. If you can catch these problems early, you can avoid falling into a trap.
1. Doesn’t Seem Hot Enough
If you’re using the same settings you’ve always used and drying times continue to increase, you’ve got a problem that is probably costing you money. Every second the dryer runs, you’re paying the power bill. Getting this taken care of quickly should save you money now and in the long run. There are two possible culprits dryer repair altadena.
If you have a moisture sensor in your dryer, it is likely faulty. Moisture sensors are connected to the main circuit board and send electrical signals to your machine, telling it how moist your clothes are. If that is faulty, it could send incorrect signals. Your clothes might even be dry and the machine just keeps running because it doesn’t know that. In the short term, you could set your clothes on a timed cycle to see if they get dry, but you should definitely call a dryer repair specialist. If it is a problem with the circuit board, you don’t want it to get worse and more expensive.
The other culprit could be a malfunctioning thermostat. This device, much like the thermostat in your home, tells your appliance the temperature inside the drum. If that malfunctions, your machine might not heat up, thus your clothes aren’t getting dry. You can open the machine about halfway through the cycle to see if it’s hot. If it is hot, you probably have a faulty moisture sensor. If it’s not, you probably have a faulty thermostat. Either one could also indicate a bigger problem with your circuit board.
2. Seems Too Hot
An appliance that seems too hot usually means one of three things: either your vent is clogged, your thermostat is faulty, or your heating coil is malfunctioning. You need to address this issue immediately, because an overheating dryer is a serious fire hazard.
Locate the lint trap. Open it up. If it’s full of lint, that might be your problem. Clean it out and run your dryer again, while keeping a close eye on it. If it continues to heat up more than you’re comfortable with, turn it off and call a dryer repair specialist. You might have a thermostat or heating coil issue. Your best bet there is just to turn it off and not to use it until a professional inspects it.
3. Rocking or Knocking
This is the easiest one to diagnose. If you have heavy items like comforters in your machine, try to re-balance those to keep the drum from rocking. If it’s not imbalanced, you probably have a damaged drive belt that’s going to need a professional eye.